Terex Genie S-120 Service Manual

Also see for Genie S-100: Maintenance manual Maintenance manual Maintenance manual Operator's manual supplement Operator's manual

Part No. 102916 S-100 • S-105 • S-120 • S-125 4 - 27January 2016 Section 4 • Repair Procedures12 Remove the pin retaining fasteners from thejib boom lift cylinder rod-end pivot pin. Do notremove the pin.13 Slide both of the jib boom leveling arms off ofthe jib boom pivot pin and lay them off to theside.14 Attach a lifting strap from an overhead craneto the lug on the rod end of the jib boom liftcylinder.15 Use a soft metal drift to remove the jib boomlift cylinder rod-end pivot pin. Remove the jibboom lift cylinder from the jib boom bellcrank.Crushing hazard. The jib boom liftcylinder may become unbalancedand fall when it is removed fromthe machine if it is not properlysupported.16 Attach a lifting strap from an overhead crane tothe jib boom bellcrank.17 Support the rod end of the platform levelingcylinder with a suitable lifting device. Protectthe cylinder rod from damage.18 Remove the pin retaining fastener from theplatform leveling cylinder rod-end pivot pin.19 Use a soft metal drift to remove the platformleveling cylinder rod-end pivot pin.Crushing hazard. The platformleveling cylinder may fall if it is notproperly supported when the rod-end pivot pin is removed.Crushing hazard. The jib boombellcrank may fall if it is notproperly supported when theplatform leveling cylinder rod-endpivot pin is removed.20 Remove the pin retaining fastener from the jibboom bellcrank pivot pin.21 Use a soft metal drift to remove the jib boombellcrank pivot pin. Remove the jib boombellcrank from the machine.Crushing hazard. The jib boombellcrank may become unbalancedand fall if it is not properlysupported when it is removed fromthe machine.JIB BOOM COMPONENTS, S-105 AND S-125 MODELS