Call recording 189Enhanced functions:1. A conference1 can be set up or cleared down during recording.2. A consultation can be performed during recording.3. Call transfer is also available during recording.4. A second call can be accepted during recording.The following features are not supported:1. Playing back recordings over the telephone.2. Deleting recordings over the telephone.3. Functions for editing recordings over the telephone.Recording tipsYou will receive the following advisories while a call is being recorded:• The recording symbol | on the display (permanent)• Beep (repeated at intervals for you and your call partner)• Beep (single at the start of recording for you and your call partner)The audible advisory can also be switched off. Please check with the relevantadministrator.MultilineThere is no difference between multi-line calls and single-line calls when itcomes to recording calls. If recording has started, the call is recorded, otherwisenot. The recording status of a line continues as long as calls are connected tothis line.For example, if line A is being recorded (manually triggered) and the callerswitches to line B or puts line A on manual hold and switches to line B, the re-cording is ended and a partial recording is saved.If recording for the call on line B is disabled (operating mode = Manual or Au-toStart) and the caller switches to line A, the recording for line A is not restarted.The operating modes mentioned (All Calls, AutoStart or Manual) refer to the tele-phone and are therefore the same for all linesRecording callsAutomatic call recordingThis is the simplest mode. If you have accepted a call or called a subscriber andthe subscriber answers, the call is recorded automatically. Refer to Page 188to check which calls this can be.As soon as the recording starts, you will see the recording symbol | and heara beep (see also Page 189).You cannot pause the recording manually in this mode.1. Server-based conference only