Unitech MS852B Plus User Manual

Also see for MS852B Plus: Quick start guide Quick start guide

- 47 - © 2020 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS852B Plus User’s Manual2.32 Data Formatting2.32.1 Data Format Editor IntroductionYou may use the Data Format Editor to change the scan engine’s output. Forexample, you can use the Data Format Editor to insert characters at certainpoints in bar code data as it is scanned. The selections in the following pagesare used only if you wish to alter the output. Default Data Format setting =None. Normally, when you scan a bar code, it is output automatically. However,when you create a format, you must use a “send” command within the formatprogram to output data.Multiple formats may be programmed into the scan engine. They are stackedin the order in which they are entered. However, the following list presents theorder in which formats are applied:1. Specific Terminal ID, Actual Code ID, Actual Length2. Specific Terminal ID, Actual Code ID, Universal Length3. Specific Terminal ID, Universal Code ID, Actual Length4. Specific Terminal ID, Universal Code ID, Universal Length5. Universal Terminal ID, Actual Code ID, Actual Length6. Universal Terminal ID, Actual Code ID, Universal Length7. Universal Terminal ID, Universal Code ID, Actual Length8. Universal Terminal ID, Universal Code ID, Universal LengthThe maximum size of a data format configuration is 2000 bytes, which includesheader information. If a bar code is read that fails the first data format, the nextdata format, if there is one, will be used on the bar code data. If there is noother data format, the raw data is output. If you have changed data formatsettings, and wish to clear all formats and return to the factory defaults, scanthe Default Data Format code below.Default Data Format*