7Compose start characterScanning / Triggering - Software Trigger - stop character [ETX] (03h) (*)704403Turn off after good read- When active, the scan engine stops the reading session after a successfuldecoding.- Turn off after good read is only used in the following trigger modes:- Level- Pulse- Autostand- Standard Aim- NOTE: this parameter is NOT used with continuous and flashing modes.Scanning / Triggering - Turn off after good read - Enable (*)704601Scanning / Triggering - Turn off after good read - Disable704600Retrigger delay- Only valid if "Turn off after good read" is disabled.- This setting is a time delay in which the scanner turns off after a good read.When the delay is done, the scanner automatically turns back on (retriggers).- Value is in milliseconds.
