Unitech MS926 User Manual

Also see for MS926: Quick start guide Quick start guide Quick start guide Quick start guide User manual

Contents

Unitech MS926 User Manual Manual pdf 103 page image

- 89 -MS926 User’s Manual4.7 Prefix/Suffix selections4.7.1 To Add a Prefix or SuffixStep 1. Scan the Add Prefix or Add Suffix symbol.Step 2. Determine the 2 digit Hex value from the Symbology Chart (included inthe Symbology Charts) for the symbology to which you want to applythe prefix or suffix. For example, for Code 128, Code ID is “j” and HexID is “6A”.Step 3. Scan the 2 hex digits from the Programming Chart or scan 9, 9 for allsymbologies.Step 4. Determine the hex value from the ASCII Conversion Chart (Code Page1252), for the prefix or suffix you wish to enter.Note: To add the Code I.D., scan 5, C, 8, 0.To add AIM I.D., scan 5, C, 8, 1.To add a backslash (\), scan 5, C, 5, C.To add a backslash (\) as in Step 7, you must scan 5C twice – once tocreate the leading backslash and then to create the backslash itself.Step 5. Scan the 2 digit hex value from the Programming Chart.Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.Step 7. Scan Save to exit and save, or scan Discard to exit without saving.Repeat Steps 1-6 to add a prefix or suffix for another symbology.Example: Add a Tab Suffix to All Symbologies :Step 1. Scan Add Suffix.Step 2. Scan 9, 9 from the Programming Chart to apply this suffix to allsymbologies.Step 3. Scan 0, 9 from the Programming Chart. This corresponds with the hexvalue for a horizontal tab, shown in the ASCII Conversion Chart (CodePage 1252).Scan Save, or scan Discard to exit without saving.