- 104 -MS926 User’s ManualFE is the “Compare characters” command31 is the hex value for 1F7 is the “Move the cursor to the beginning” commandF2 is the “Send a number of characters” command06 is the number of characters to send0D is the hex value for a CRThe data is output as:123456￭ Move the cursor to the endEA Move the cursor to the last character in the input message. Syntax = EA.4.8.4.3 Search Commands￭ Search forward for a characterF8 Search the input message forward for “xx” character from the currentcursor position, leaving the cursor pointing to the “xx” character. Syntax =F8xx where xx stands for the search character’s hex value for its ASCIIcode. Refer to the ASCII Conversion Chart (Code Page 1252), fordecimal, hex and character codes.F8 Example: Send bar code data that starts after a particular characterSearch for the letter “D” in bar codes and send all the data that follows,including the “D.” Using the bar code above:Command string: F844F10DF8 is the “Search forward for a character” command44 is the hex value for “D”F1 is the “Send all characters” command0D is the hex value for a CRThe data is output as:DEFGHIJ
