- 96 -MS926 User’s Manual4.8.4 Data Format Editor CommandsWhen working with the Data Format Editor, a virtual cursor is moved alongyour input data string. The following commands are used to both move thiscursor to different positions, and to select, replace, and insert data into the finaloutput.4.8.4.1 Send Commands￭ Send all charactersF1 Include in the output message all of the characters from the inputmessage, starting from current cursor position, followed by an insertcharacter. Syntax = F1xx where xx stands for the insert character’s hexvalue for its ASCII code. Refer to the ASCII Conversion Chart (Code Page1252), for decimal, hex and character codes.￭ Send a number of charactersF2 Include in the output message a number of characters followed by aninsert character. Start from the current cursor position and continue for“nn” characters or through the last character in the input message,followed by character “xx.” Syntax = F2nnxx where nn stands for thenumeric value (00-99) for the number of characters, and xx stands for theinsert character’s hex value for its ASCII code. Refer to the ASCIIConversion Chart (Code Page 1252), for decimal, hex and charactercodes.
