Vacon 100 Applications Manual
Also see for 100 INDUSTRIAL: Installation instructionInstallation manualInstallation manualInstallation manualUser manual
                                                                                                                                                                                                                                      | |
Contents
| 
Vacon 100 - Startup vacon • 1224-hour support +358 (0)201 212 575 • Email: vacon@vacon.com11.2 Multi-Pump wizardThe Multi-Pump wizard is activated in the Quick Setup/Wizards menu (B1.1.3). The Multi-Pump wizard asks the most important questions for setting up a Multi-Pump system.This wiz-ard presupposes that you are going to use the PID controller in the "one feedback / one set-point" mode. The control place will be I/O A and the default process unit ‘%’.The Multi-Pump wizard asks for the following values to be set:If any other process unit than ‘%’ is selected the following questions appear: If not the Wizardwill directly jump to step 5.If one of the analogue input signals is selected the question 6 appears. Otherwise you will betaken to question 7.If one of the analogue input signals is selected the question 9 appears. Otherwise you will betaken to question 11.If either of the options Keypad Setpoint 1 or 2 is chosen the question 10 will appear.If option ‘Yes’ is selected you will be prompted for three more values:1 Process unit selection (P3.13.1.4) Several selections.2 Process unit min (P3.13.1.5) Depends on selection at step 1.3 Process unit max (P3.13.1.6) Depends on selection at step 1.4 Process unit decimals (P3.13.1.7) 0...45 Feedback 1 source selection(P3.13.3.3) See page 135 for selections.6 Analogue input signal range0 = 0…10V / 0…20mA1 = 2…10V / 4…20mASee page 111.7 Error inversion (P3.13.1.8) 0 = Normal1 = Inverted8 Setpoint source selection(P3.13.2.6) See page 133 for selections.9 Analogue input signal range0 = 0…10V / 0…20mA1 = 2…10V / 4…20mASee page 111.10 Keypad setpoint (P3.13.2.1/P3.13.2.2)Depends on selection at step 1.11 Sleep function? NoYes12 Sleep frequency limit 1 (P3.13.5.1) 0.00...320.00 Hz13 Sleep delay 1 (P3.13.5.2) 0...3000 s14 Wake-up level 1 (P3.13.5.6) Range depends on selected pro-cess unit.15 Number of motors (P3.15.1) 1...6 |
Related manuals for Vacon 100 INDUSTRIAL
Vacon 100 hvac Applications Manual
Vacon 100 hvac Applications Manual
Vacon 100 flow Applications Manual
Vacon 100 flow Applications Manual
Vacon 100X series Applications Manual
Vacon 20 CP/X Applications Manual
Vacon NX series Applications Manual
Vacon NX Series Applications Manual
Vacon NX Series Applications Manual
Vacon 20 SERIES Applications Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine