V2.4.4 PID1 OUTPUT (ID 23)This monitoring value shows the output of the PID controller as a percentage (0-100%).V2.4.5 PID1 STATUS (ID 24)This monitoring value shows the state of the PID controller.9.4 PID2 CONTROLLERV2.5.1 PID2 SETPOINT (ID 83)This monitoring value shows the value of the PID setpoint signal in process units.You can use the parameter P3.13.1.9 to select the process unit (See 10.12.1 Basic settings).V2.5.2 PID2 FEEDBACK (ID 84)This monitoring value shows the value of the PID feedback signal in process units.You can use the parameter P3.13.1.9 to select the process unit (See 10.12.1 Basic settings).V2.4.3 PID2 ERROR VALUE (ID 85)This monitoring value shows the error value of the PID controller.The error value is the deviation of PID feedback from the PID setpoint in process unit.You can use the parameter P3.13.1.9 to select the process unit (See 10.12.1 Basic settings).V2.5.4 PID2 OUTPUT (ID 86)This monitoring value shows the output of the PID controller as a percentage (0-100%).You can give this value to, for example, the analogue output.V2.5.5 PID2 STATUS (ID 87)This monitoring value shows the state of the PID controller.9.5 MULTI-PUMPV2.6.1 MOTORS RUNNING (ID 30)This monitoring value shows the actual number of motors that operate in the Multi-pumpsystem.V2.6.2 AUTOCHANGE (ID 1114)This monitoring value shows the status of the autochange requested.MONITORING VALUE DESCRIPTIONS VACON · 10924-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM 9
