3 Move from digit to digit with the arrow buttons Leftand Right. Change the digits with the arrow buttonsUp and Down.4 Accept the change with the OK button. To ignorethe change, go back to the level where you werebefore with the Back/Reset button.3.3.2 RESETTING A FAULTTo reset a fault, you can use the Reset button or the parameter Reset Faults. See theinstructions in 11.1 A fault comes into view.3.3.3 THE FUNCT BUTTONYou can use the Funct button for 3 functions.• To have an access to the Control page.• To easily change between the Local and Remote control places.• To change the rotation direction.The selection of the control place determines from where the AC drive takes the start andstop commands. All the control places have a parameter for the selection of the frequencyreference source. The Local control place is always the keypad. The Remote control place isI/O or Fieldbus. You can see the current control place on the status bar of the display.It is possible to use I/O A, I/O B and Fieldbus as Remote control places. I/O A and Fieldbushave the lowest priority. You can make a selection of them with P3.2.1 (Remote ControlPlace). I/O B can bypass the Remote control places I/O A and Fieldbus with a digital input.You can make a selection of the digital input with parameter P3.5.1.5 (I/O B Control Force).The keypad is always used as a control place when the control place is Local. Local controlhas higher priority than Remote control. For example, when you are in Remote control, ifparameter P3.5.1.5 bypasses the control place with a digital input, and you make a selectionof Local, Keypad becomes the control place. Use the Funct button or P3.2.2 Local/Remote tochange between the Local and Remote control.CHANGING THE CONTROL PLACE1 Anywhere in the menu structure, push the Functbutton. READY FAULTALARMSTOPRUNKEYPADI/OREVFWD BUSUSER INTERFACES VACON · 3924-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM 3
