Vega VEGAPULS 69 Operating Instructions Manual

Also see for VEGAPULS 69: Operating instructions Mounting instructions Product information Quick setup guide Operating instructions

Contents

113 Product descriptionVEGAPULS 69 • 4 … 20 mA/HART - two-wire47247-EN-150211parameter adjustment of these instruments, the adjustment softwarePACTware with VEGA-DTM is required.You can find further information in the operating instructions "Interfaceadapter VEGACONNECT" (Document-ID 32628).The VEGADIS 81 is an external display and adjustment unit for VEGAplics® sensors.For sensors with double chamber housing the interface adapter"DISADAPT" is also required for VEGADIS 81.You can find further information in the operating instructions "VE-GADIS 81" (Document-ID 43814).The adapter "DISADAPT" is an accessory part for sensors with dou-ble chamber housings. It enables the connection of VEGADIS 81 tothe sensor housing via an M12 x 1 plug.You can find further information in the supplementary instructions"Adapter DISADAPT" (Document-ID 45250).VEGADIS 82 is suitable for measured value indication and adjustmentof sensors with HART protocol. It is looped into the 4 … 20 mA/HARTsignal cable.You can find further information in the operating instructions "VE-GADIS 82" (Document-ID 45300).PLICSMOBILE T61 is an external GSM/GPRS radio unit for transmis-sion of measured values and for remote parameter adjustment ofplics® sensors. Adjustment is carried out via PACTware/DTM and theintegrated USB connection.You can find further information in the supplementary instructions"PLICSMOBILE T61" (Document-ID 37700).PLICSMOBILE is an internal GSM/GPRS radio unit for transmissionof measured values and for remote parameter adjustment of plics®sensors. Adjustment is carried out via PACTware/DTM and the inte-grated USB connection.You can find further information in the supplementary instructions"PLICSMOBILE GSM/GPRS radio module" (Document-ID 36849).The protective cover protects the sensor housing against soiling andintense heat from solar radiation.You will find additional information in the supplementary instructionsmanual "Protective cover" (Document-ID 34296).Screwed flanges are available in different versions according to thefollowing standards: DIN 2501, EN 1092-1, BS 10, ASME B 16.5,JIS B 2210-1984, GOST 12821-80.You can find additional information in the supplementary instructionsmanual "Flanges according to DIN-EN-ASME-JIS" (Document-ID31088).VEGADIS 81DISADAPTVEGADIS 82PLICSMOBILE T61PLICSMOBILEProtective capFlanges