WAGO-I/O-SYSTEM 750 Commissioning 99750-666/000-003 4FDI/2FDO 24V/10A PROFIsafe V2 iParManualVersion 1.4.0, valid from HW/SW Version 01/01Pos: 47.1 /Serie 750 (WAGO-I/O-SYSTEM)/In Betrieb nehmen/Parametrieren mit WAGO-I/O-CHECK/Parametrieren 750-66x/Parametrierung 75x-066x mit WAGO-I/O-CHECK 3.2 @ 5\mod_1246888298921_21.docx @ 36694 @ 233 @ 18.3 Parameterization of the PROFIsafe I/O Module withthe WAGO Parameterization ToolOnly qualified persons may perform these tasks!Adding, exchanging and starting up PROFIsafe I/O modules may only be carriedout by personnel trained in safety-related procedures!Check safety functions!Before start up, all safety functions must be checked for their specifiedeffectiveness!Only operate PROFIsafe I/O modules with active password protection!Without using the iPar functionality, PROFIsafe I/O modules may only beoperated in safety-related applications with active password protection.PROFIsafe I/O modules may be operated in safety-related applications withoutactive password protection if the PROFIsafe I/O module is operated with iParfunctionality (see the "PROFIsafe I/O Module with iPar Functionality withoutiPar Server" section).The WAGO Safety Editor 75x 2.x can be started with different call options.Depending on the call option, the Safety Editor is started in either ONLINE orOFFLINE mode.ONLINE mode is used to change the parameter data of a PROFIsafe I/O moduledirectly.OFFLINE mode is used to create or change parameter data of a PROFIsafe I/Omodule in a parameter file.