WAGO MOVILINK SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767 Connecting Data and Supply Cables 43767-5204 MOVILINK® Interface (RS-232, RS-485)ManualVersion 1.1.0• Do not use drop lines under any circumstances. This can lead to amplifiedline reflections and signal distortions, which greatly impair the transmissionquality.Pos : 24.9 /Serie 767 (WAGO-SPEED WAY)/Ans chl uss D aten- und Vers orgungs kabel/I/O-Modul e/Ans chl uss _Hinweise T eil 3.1 @ 8\mod_1278314911479_21.doc x @ 58959 @ @ 1• Observe the exact positioning (coding) between plug and socket.• Keep all cables a sufficient distance away from electromagnetic sources ofinterference in order to maintain a high level of interference resistance ofthe 767 system against electromagnetic emissions.• Observe the minimum bending radiuses of the WAGO system cable. Formore information, see the technical data at www.wago.com.• When laying all cable, ensure that you do not lay it in shear areas of movingmachine parts.• Observe the correct layout of the potential equalization.Pos : 24.10 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Z ubehör allgemein @ 5\mod_1249287357968_21.doc x @ 39869 @ 2 @ 15.2 Required AccessoriesThe WAGO accessories listed below are required for connecting the data andsupply cable. The associated item numbers can also be found in the fieldbusmanuals for 767 Series, in the "Accessories" section. Select the manualappropriate to the 767 Series fieldbus you are using.• S-BUS M12 terminator, IP 67• S-BUS and supply cables, pre-assembled on both ends, IP 67• Torque wrench• Protective capsPos : 24.11 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1