WAGO MOVILINK SPEEDWAY 767 Manual
                                                                                                                      |
WAGO-SPEEDWAY 767 Diagnostics 99767-5204 MOVILINK® Interface (RS-232, RS-485)ManualVersion 1.1.0Pos : 42 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Diag nos e/Di agnos e - Ü bersc hrift 1 @ 4\mod_1240831069471_21.doc x @ 31372 @ 1 @ 110 DiagnosticsPos : 43 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Diag nos e/LED-Signalisierung - Ü bers chrift 2 @ 4\mod_1240831118032_21.doc x @ 31375 @ 2 @ 110.1 LED SignalingPos : 44.1 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen Einl eitung @ 7\mod_1268130796113_21.doc x @ 52028 @ @ 1The following table lists the operating messages that are indicated via LEDs.Information regarding remedies of certain causes is also provided.Pos : 44.2 /Serie 767 (WAGO-SPEED WAY)/Wic htige Erläuterungen/Sicherheits hinweis e/Hi nweis /Hinweis: 767- 4xxx/- 5xxx Betriebs meldungen Deakti vierbar e Diag nos en @ 7\mod_1265892089421_21.doc x @ 50332 @ @ 1Disabling specific diagnosticsUse the diagnostic overview (section "Parameterizing" > "Diagnostic Overview")to disable specific diagnostics (see F- and I/O-LED). In this case, thecorresponding LED is disabled (off).Pos : 44.3 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx Abbildung 4xM 12 @ 5\mod_1249454812578_21.doc x @ 40396 @ @ 1Figure 28: LEDs indicating operational messages (exemplary)Pos : 44.4 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx Allgemei n (Pos.15, T eil 1) @ 5\mod_1249461825765_21.doc x @ 40406 @ @ 1Table 56: Operating messages 1Pos. LED Color/Status Cause Remedy/information15 SBOff Low voltage;U LS not available.Check the power supply.Red, flashing,4 HzS-BUS error on module. Check whether the S-BUScable is connected.Check the S-BUS cable fordamages.Check whether the fieldbuscoupler firmware iscompatible with the module.Red, flashing,1 or 2 HzThe module is being restartedvia the fieldbus coupler.If the flashing frequency is1Hz, please contact WAGOSupport.Green Data exchange is in process;process data values are valid.The module is in RUN mode.-151716171819 |
Related manuals for WAGO 767-5204
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine