Operation RD 12/RD 12Awc_tx000865gb.fm 282.5 StartingSee Graphic: wc_gr002951Exhaust gases are toxic. Do not start the engine in an enclosed space.2.5.1 Sit down in the operator’s seat and fasten the seat belt.2.5.2 Set the forward/reverse control (15) in the neutral position.2.5.3 If the engine is cold, move the choke lever (44) to the left into theCLOSED position. If the engine is warm, move the choke control to theright in the OPEN position.Note: The roller will not start unless the forward/reverse control is inthe NEUTRAL position.2.5.4 Check that the parking brake (42) is set. To set the brake, pull thebrake lever up until the brake pad engages the drum. To release thebrake lever, lower the lever. Always set the parking brake beforeleaving the machine.2.5.5 Turn the ignition switch (55) to start the engine. If the vibration indicatorlight (50) is on, turn the vibration off by pressing the vibration controlbutton (10).NOTICE: Do not crank the engine starter for more than 15 seconds atone time. Longer cranking cycles could lead to starter damage.Note: The ignition switch has an anti-restart feature. If the engine doesnot start, the switch will need to be turned to the OFF position before itwill allow the engine to be cranked again.2.5.6 Gradually place the choke lever in the OPEN position as the enginewarms up. Allow the engine to warm up for a few minutes beforeoperating the roller.2.5.7 Before moving the machine, release the parking brake by lowering thebrake lever.2.5.8 Quickly press and release the upper half of the throttle switch (54) tobring the engine to high throttle.Prolonged exposure to high noise levels can damage your hearing.Wear appropriate hearing protection while operating the roller.WARNINGWARNING
