RD 12/RD 12A Disassembly & Assemblywc_tx000671gb.fm 979.21 Removing the Control Cable and Control LeverPrerequisites Machine OFF and engine cool Seat platform in raised positionProcedure Follow the procedure below to remove the control cable and the control lever.1. Disconnect the control cable (a) from the drive pump.2. Cut the wire ties (b) that secure the hoses, wires, and cables. Maneuver the cablearound the engine so that it is free up to the control lever.3. Disconnect the wiring at the connector (c).4. Remove the cable clamp (d).This procedure continues on the next page.CAUTION! Burn hazard. The engine exhaust pipes are extremely hot while theengine is running and for a period of time after the engine has shut down.f Allow the exhaust pipes to cool before performing this procedure.wc_gr004189a bwc_gr004190cd
