Walker MT Detailed Instructions

Also see for MB: Owner's manual Parts and owners manual

Walker MT Detailed Instructions Manual pdf 27 page image

Page: 1-7WALKER MANUFACTURING COMPANYJuly 2006SERVICE INSTRUCTIONSMower Deck AssemblyDeck Caster Wheels Installation - All Models1. Remove the bolt, nut, axle spacer tube, and spacerwashers from each deck caster wheel fork.2. Fit the axle spacer tube through the wheel hub, po-sition the spacer washer on each side of the hub (ifused), and fit the assembly into the wheel fork.3. Insert the 3/8-16 x 4-1/2 in. bolt through the wheelfork with the bolt head to the outside and install the3/8-16 in. Keps nut.4. Tighten the bolt and nut until the axle spacer tubebottoms against the inside of the wheel fork (willnot turn) while the wheel and spacer washers (ifused) spin freely without binding.Deck Caster Wheel Installation5. Grease the caster wheel bearings and caster pivotbearings - one grease fitting for each wheel andeach pivot.Deck Discharge Chute Installation(GHS Rear Discharge Models Only) - Model MS, MC,MD, MT, MTL, MTEFIMount the discharge chute hinge on top of the deck dis-charge opening using the 1/4-20 x 1/2 in. socket buttonhead bolt and 1/4-20 ESNA nut. Position the bolt withthe head inside of the chute and the nut on the outside.Attach spring for tilt-up action from chute to bracket ondeck.Discharge Chute and PTO Shaft GuardInstallation on Rear Discharge DeckDeck Discharge Shield Installation(Side Discharge Models Only) - All ModelsAttach the deck side discharge shield by positioning theshield hinge lug in front of the deck mount and fasten-ing with two 3/8-16 x 1-1/4 in. bolts, 3/8-16 ESNA nuts,and 3/8 in. wave spring washers. The wave washers fitbetween the two hinging surfaces. Tighten the nuts un-til the shield moves freely but is not loose.Spacer WasherGrease FittingLocationsAxle Spacer TubeWARNINGDO NOT operate the machine without thegrass deflector shield attached and in thelowest possible position.Attach GuardAttachChuteNut on TopCarrier FrameTube Sockets