Walker MT Detailed Instructions

Also see for MB: Owner's manual Parts and owners manual

Walker MT Detailed Instructions Manual pdf 36 page image

Page: 1-16WALKER MANUFACTURING COMPANYJuly 2006SERVICE INSTRUCTIONSImplement AssemblySETUP INSTRUCTIONSPerfaeratorThe PERFAERATOR™ is shipped partially assembled.After uncrating, initial setup is required.NOTE: During the process of unpacking, any dam-aged or missing parts should be noted and reported tothe delivering carrier immediately (put in writing within15 days). The carrier will provide directions for pro-ceeding with a claim to receive compensation fordamage.Lift Lever InstallationThe lift lever for the camshaft assembly position is par-tially assembled. Stand the lift lever upright and attachthe remaining hardware.Install Lift Lever Handle(stand upright and insert hardware)Installation on Tractor1. Remove the mower deck from the tractor if neces-sary. Refer to the appropriate Tractor Owner'sManual.2. Lightly grease each tractor support arm (2) on thetractor.Attach Aerator to Tractor3. Engage the aerator frame tube sockets on the trac-tor support arms. Slide the implement hitch ontothe support arms approximately 3 in. (76 mm).Connect Driveline Coupler to Tractor PTO4. Connect the aerator driveline to the tractor PTOshaft by sliding back the locking collar on the yoke,then push the yoke over the PTO shaft until thelocking collar snaps back fully. Make sure thedriveline is well secured at both ends.5. Install the hitch pin through the hole on the end ofeach support arm to lock the hitch in place. Two (2)hitch pins are included in the owner’s packet of ma-terials.Lift LeverDANGERThis shaft turns at very high RPM. If thecollar is not locked to the PTO shaft at thetractor end, or if the yoke at the aeratorend is not secured properly, the drivelinecan fly loose with great force capable ofcausing serious injury or death.MountingTubesOnly use PTO U-JointTube P/N 7275-15(9.06" OAL)