Walker MT Detailed Instructions

Also see for MB: Owner's manual Parts and owners manual

Walker MT Detailed Instructions Manual pdf 41 page image

Page: 1-21WALKER MANUFACTURING COMPANYJuly 2006SERVICE INSTRUCTIONSDOZER BLADEDozer Blade Assembly1. Insert the female quick hitch into the hitch box onthe blade attachment.2. Align the single hole at the end of the female quickhitch with the single hole in the hitch box and insertthe pivot pin through both holes. Secure the pivotpin on the underside with a 1/4 x 1 in. roll pin.Insert Female Hitch into Blade Attachment3. Hook one end of the spring onto the welded tab onthe hitch box. Hook the eyebolt onto the free endof the spring.4. Insert the eyebolt up through the hole in the upperbend of the blade and secure it with a flat washerand nut. Adjust the length of the eyebolt accordingto the amount of spring tension required for safeoperation. [Normally about 1/2 in. (13mm) ofthread should protrude beyond the nut.]Attach Spring to Blade Assembly5. Insert a 3/16 x 1 in. split spring pin into the angleadjustment pin.6. Rotate the female quick hitch to obtain the requiredblade angle. Align the hole in the center of the fe-male quick hitch with one of the five (5) holes in thehitch box, and insert the angle adjustment pinthrough the top and bottom holes.Insert Adjustment Pin and Set Blade Angle7. Install the two (2) skid shoes in the two brackets onthe rear outer edges of the blade.FemaleQuick HitchRoll PinPivot PinHitch BoxAlign HolesNutEyeboltSpringWelded TabRotate Female Quick HitchFor Required Blade AngleAngle Adjustment Hole(s)Angle AdjustmentPinFemale QuickHitch