Walker MT Detailed Instructions

Also see for MB: Owner's manual Parts and owners manual

Walker MT Detailed Instructions Manual pdf 52 page image

Page: 1-32WALKER MANUFACTURING COMPANYJuly 2006SERVICE INSTRUCTIONSModel MS, MB, MC, MD, MT, MTL, MTEFI3. Remove the PTO cover (between the footrests).Remove the shipping wire from the counterweightsprings, place the lift handle in the UP (back)position, and hook the counterweight springs ontothe hook tabs on the frame. The tabs are locatedbelow the right angle gearbox and drive shaft (referto Counterweight Spring Hook Tab Locationsphoto).Counterweight Spring HookTab Locations (bottom view)4. Install the spout assembly.Install Spout Assemblya. Place the chute on the chute base and alignthe holes of the three (3) retaining plateswith the holes in the chute base. Attach therear and right hand side retaining plates withone (1) 1/4-20 x 1/2 bolt in the forward mosthole and the front retaining plate with two (2)1/4-20 x 1/2 bolts and secure with four (4)1/4-20 flange nuts.b. Insert the two (2) 1/4-20 x 1-3/4 bolts in therotation stopper, the spacer rings and throughthe remaining holes of the rear and right handside retaining plates and secure in place withtwo (2) 1/4-20 nuts. Tighten the nuts firmly.c. Insert one (1) grommet in rotation supportand one (1) grommet in handle support,mount handle support and rotation handle toblower using two (2) 1/4-20 x 1/2 bolts andtwo (2) 1/4-20 flanged nuts.d. Install 1/2” plastic handle on rotation handle.5. Lightly grease the tractor support arms.6. Engage the snowblower mounting tubes on thetractor support arms.Engage Snowblower Mounting Tubeswith Tractor Support Arms7. Slide the snowblower onto the tractor support armsand connect the snowblower PTO shaft to the trac-tor with the PTO quick coupler as follows:NOTE: Model MS and earlier Model MC do nothave the PTO quick coupler. Use sliding joint toconnect tractor to snowblower PTO.a. Place the pilot end of the snowblower PTOshaft into the socket of the PTO quick couplerand rotate the PTO shaft until it is aligned cor-rectly with the socket in the PTO quick cou-pler, then slide together. Use arrows on theshaft and tube for correct alignment.Remove PTO Cover BeforeAttaching Springs To FrameSpring Hook TabsSpout DischargeGuard(not shown)Mounting TubesSupport Arms