Wayne-Dalton 800 Installation Instructions Manual

Wayne-Dalton 800 Installation Instructions Manual Manual pdf 17 page image

www.Wayne-Dalton.com 349981 REV2_05/17/2016©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation17Installation (continued)14. MOUNTING ... (continued)B. Find a suitable and easily accessible location for the Junction Box,Fig. 4–S(a).• Locate Junction Box on the wall near the Position Sensor, Crank HandleRetainer, and Motor, but OUTSIDE the end cover and its full open swingrange. Verify component cables will reach before mounting JunctionBox and that the end cover full open swing range does not interfere withaccess to Junction Box.• Away from heat sources.• With no interference of moving parts of the door system.• Where cables can be well secured while preventing unnecessary strain.• Use the Junction Box exterior mounting fixtures to mount to wall.(Fasteners not provided.)• Attach the Hand Crank Interlock switch cable to the Junction boxconnector position 2 labeled “HAND CRANK INTERLOCK” See Fig. 5–J onpage 28.C. Find a suitable and easily accessible location for the Control Panel,Fig. 4–S(b).• Adjacent to the door, on the wall, about 5 feet above the floor at thecenter of the panel (roughly eye level). It may be mounted higher incommercial applications to reduce tampering.• Where all moving parts of the door system are visible while at the controlpanel.• Away from heat sources.• With no interference of moving parts of the door system.• Where cables can be well secured while preventing unnecessary strain.• Mount the Control Panel to the wall. (Fasteners not provided.) Usesupplied mounting tabs as necessary.Fig 4–S(c)D. Photoeye assemblies are factory mounted to their protective shields.Attach to guides as follows, Fig. 4–S(c).1. Mount the Photoeye Receiver (pre-wired cable) to the lowest guideassembly bolt so that the Photoeye is aimed toward the opposite guide.Route the cable up and plug into the Junction Box connector position 4labeled “Photoeye RX” see FIG 5-J page 28.2. Mount the Photoeye Transmitter (long pre-wired cable) to the lowestguide assembly bolt on the opposite guide, directly across from thereceiver. Route the wire up the guide and over the header to the JunctionBox to connector position 3 labeled “Photoeye TX” FIG 5-J, page 283. Photoeyes will be aligned later, when power is applied to the ControlPanel. See page 29 Photoeye Adjustment.PANELPANELGUIDEHOLES FOR CONTROLINTERIOR MOUNTINGCONTROLUSE APPROPRIATEFASTENERS FORWALL TYPEFig 4–S(a)Fig 4–S(b)PHOTOEYEPhotoeyes are attachedto their protective shieldsat the factory and mustbe mounted to the guidesusing the hardware provided.For parking garage applicationsPhotoeyes may be mounted higherto prevent the beam from shootingbeneth vehicles.Use Fastenersappropriate forwall materialJunction BoxMounting HolesCrank SupportBracketMounting Holes