Wayne-Dalton 800 Installation Instructions Manual

Wayne-Dalton 800 Installation Instructions Manual Manual pdf 20 page image

www.Wayne-Dalton.com349981 REV2_05/17/2016 ©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation20Installation (continued)17. INSTALL SAFETY LABELS, Fig. 4–VProduct safety labels must be installed.A. Find Safety Labels in hardware box.B. Attach Motor Brake Release Pull Cord Tag to the motor pull cord.C. Attach Sensing Edge Safety Label to the bottom bar.D. Place remaining Safety Label at a readable height on door drive side guideor jamb.NOTE: Product safety labels should be periodically inspected and cleaned by theproduct user as necessary to maintain good legibility. Order replacement safetylabels from the door manufacturer as required to maintain legibility.18. PRE-HOOD CHECK LISTWARNINGImproper use of Hand Crank can cause severe injury or death. Use extremecare when operating the door manually using the hand crank. Read andfollow the HAND CRANK OPERATION instructions on page 12 and suppliedSafety Labels before attempting to operate the door.A. Remove locking pliers or other secure clamping device.B. Remove the ropes/slings holding the curtain.C. Operate the door manually several times. Make sure the endlocks orwindlocks are not rubbing endplates through the entire travel of door.D. Check that the bottom bar is level at top and bottom and the curtain is notbinding against the back of the guides.– If curtain is level at bottom but not at top, place shims between thecurtain and barrel on the low side.E. Verify good mechanical connection and tightness of fasteners, i.e., guides,headplates, set screws.F. Position the door at the half open position.NOTE: Hood and Brush Seal installation can be delayed until the last step to alloweasy access to curtain during wiring set-up and final adjustments.19. INSTALL HOOD (interior*)A. Pre-drill the hood flange at 18" spacing for wall mounting screws. Holediameter is dependant on the size of the wall fasteners (not provided)used to attach hood to wall.B. Place the hood over the hood bands or straps on the headplates (and, ifprovided, hood supports) and against the wall, Fig. 4–W.C. Fasten the hood to the hood bands or straps.– At top, bottom and middle of the bands, drill 3/16" diameter holesthrough the hood and hood bands or straps on the headplates. Fastenthe hood to the hood bands with self-tapping screws (provided).D. Fasten the hood to the wall.– Place fasteners using the pre-drilled holes (wall fasteners not included).Fig 4–WHOOD SUPPORTS NOT SHOWNNOTE: Install hood supports (ifprovided) at even intervals acrossheader. Number and placementof hood supports will vary withhood type and width.* For EXTERIOR hood installation seeSection 7: Special Door System Features,Exterior Hood Installation on page 43.Fig 4–VSAFETY LABELRIGHT GUIDEANGLECORD TAGRELEASE PULLMOTOR BRAKESENSING EDGESAFETY LABEL