Wayne-Dalton 800 Installation Instructions Manual

Wayne-Dalton 800 Installation Instructions Manual Manual pdf 3 page image

www.Wayne-Dalton.com 349981 REV2_05/17/2016©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation3Safety InformationWARNINGAdvanced Performance service doors are large, heavy objects that move with the help of electricmotors. Since moving objects and electric motors can cause injuries, your safety and the safety ofothers depends on you reading the information in this manual. If you have any questions or do NOTunderstand the information presented, call your nearest service representative.In this section and those that follow, the words "DANGER", "WARNING", and "CAUTION" are used tostress important safety information. The word:DANGER indicates an imminently hazardous situation which, if not avoided, will result in death orserious injury.WARNING indicates a potentially hazardous situation which, if not avoided, could result in death orserious injury.CAUTION indicates a potentially hazardous situation which, if not avoided, may result in injury orproperty damage.The word NOTE is used to indicate important steps to be followed or important considerations.1. Read manual and warnings carefully.2. Keep the door in good working condition.3. This door is equipped with a sensing edge,check sensing edge operations daily.Make any necessary repairs to keep itfunctional.4. All models are equipped with anovercurrent device. This must be manuallyreset following an overcurrent condition.5. Keep instructions in a prominent locationnear the Control Panel.Section 1POTENTIALHAZARD EFFECT PREVENTIONMOVING DOORWARNINGCan Cause SeriousInjury or DeathDo NOT operate unless the doorway is in sight and free of obstructions. Keep people clear ofopening while door is moving.Do NOT change control to momentary contact unless an external reversing means is installed.Do NOT operate a door that jambs.ELECTRICAL SHOCKWARNINGCan Cause SeriousInjury or DeathTurn OFF electrical power before removing Control Panel or motor cover.When replacing Control Panel cover make sure wires are NOT pinched or near moving parts.Operator must be electrically grounded.