Wayne-Dalton 800 Installation Instructions Manual

Wayne-Dalton 800 Installation Instructions Manual Manual pdf 7 page image

www.Wayne-Dalton.com 349981 REV2_05/17/2016©Copyright 2016 Wayne Dalton, a division of Overhead Door Corporation7Section 3General InformationThe following list of items should be considered prior to installing an Advanced Performance Door.• Verify the opening measurements, head room, and side room required for this installation.• Type of door jamb.• Availability of a power supply, which side of door it is on and what the line voltage is.• Door system mounting environment. Items to consider include operator location, dampness of location, dustiness of thelocation and corrosiveness of the location.• Door activation needs and requirements. Examples include 3 button control stations, 1 button control stations, radiocontrols, pull cords, loop detectors, photoeyes, key switches, motion detectors, etc.• Accessory equipment needs and requirements. Examples include sirens, warning lights, etc.Job Site Issues/ConsiderationsDoor SpecificationsDOOR MODEL NUMBER (circle one): 800 / 800COPENING WIDTH:OPENING HEIGHT:CURTAIN COLOR:OPERATOR VOLTAGE:HEADROOM REQUIREMENT:CURTAIN WEIGHT: __________SIDE ROOM: DRIVE__________ NON-DRIVE:__________GUIDE GAP __________ GUIDE TYPE___________"S" DIMENSION __________ "G" DIMENSION__________OPERATOR: HP _________ RATIO_________MOTOR MOUNTING:: INTERIOR or EXTERIORLEFT HAND or RIGHT HAND(check one)Installation DataNAME PLATE SERIAL NUMBER:JOB NAME:DISTRIBUTOR:NOTE: The ID plate is located onthe bottom bar.Entrapment ProtectionPhotoeyes and sensing edges are required for all electrically operated Advanced PerformanceOption Service doors. Both photoeyes and sensing edge are standard with these models. Do NOTdisable them.1-800-827-3667 (DOOR)