Xerox 4050 Operator's Manual

Also see for 4050: Message guide Forms creation guide Code List Message guide Quick reference card

Contents

Xerox 4050 Operator's Manual Manual pdf 51 page image

SETTING UP PRINT JOB SOURCESWhen you enter this command, you can specify one of thefollowing:• 871—Identifies a host in an SNA/SDLC or BSC environment.• DMR—Identifies a VAX/VMS host in a DDCMP environment.• XNS—Identifies a network environment.• XPF—Identifies an IBM host in an MVS/XA or an MVS/ESAenvironment.• XPS—Identifies Xerox Print Services (XPS) Manager as theprinter front end to other hosts. (This option is available inXDDI only.)If your LPS interfaces with only one host, then HIP automaticallyperforms this function each time it is loaded.Changing hostsFollow these steps to change hosts:1. Make sure HIP is loaded and offline.Refer to the “Starting HIP” section above and “Taking HIPoffline” section later in this chapter, if you are uncertain howto perform either task.2. Enter HIP HOST, as described in the previous section, toselect a new mode.If HIP is not offline or if the system is not idle, the commandis rejected, and one or more of the following messagesdisplay:HP2020 SELECTED HOST NOT PRESENT ON SYSTEMHP2400 HIP INTERFACE MUST BE OFFLINE. ENTER HIP OFFLINEHP7100 CANNOT CHANGE HOST WHILE JOBS ARE PENDING OR ACTIVEPlacing HIP onlineFor the system to receive files, you must place the interfaceonline. Enter HIP ONLINE [ALL]:The ALL parameter specifies that both print and nonprint files areaccepted; otherwise, only print files are accepted. As print jobsare received, they are entered into the HIP job queue beforebeing entered into the Queue Manager queue.One of the following messages displays:HP1210 HOST ONLINE. Accepting ALL jobs.HP1220 HOST ONLINE. Accepting print jobs only.HP2010 No HOST selected.HP2030 ALL not allowed at current LOGON level.HP0200 Failed to go ONLINE.ONLINE ALL is accepted in logon level 2 and above for all hostsexcept for XNS hosts. HIP is always in ONLINE ALL mode forXNS hosts.If the selected host is not online and responding, the followingmessage displays every 30 seconds until the host comes onlineor the online request is terminated using HIP OFFLINE command:HP1240 HOST not responding.XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE 3-23