PRINT JOB MAINTENANCE3. If the printer has stopped, resume printing by pressing theContinue button on the printer control console, or press on the keyboard.Unloading the stitcher/stacker trayFollow these steps to unload the stitcher/stacker tray:1. Lift the black handle on the outside of the tray. Ease the trayout slowly to prevent it from falling or breaking.1. Tray handle2. Stacker armsThe tray slides down, then moves up. Make sure you let thetray slide all the way out before removing the paper.A false tray-full condition occurs when you remove smallstapled sets without pulling out the tray. The counter is notreset, causing the printer to stop before the tray is actuallyfull.2. Close the tray by sliding it back under the stacker arms.The tray clicks and slides back into place.3. If the job is not complete, printing should resumeautomatically when the tray is replaced.If it does not, press the Continue button on the printercontrol console or press on the keyboard.You can have your service representative adjust your LPS sothat printing automatically continues when the stitcher/stackertray is unloaded and replaced.Unloading the sample trayThe following occurs when 70 sheets are in the sample tray:• A message appears on the printer control console.• An audible tone sounds.If you do not empty the tray before it reaches full capacity (100sheets), the printer stops, and a message appears instructing youto empty the sample tray and press the Continue button toresume printing.Follow these steps to unload the sample tray:1. Remove the prints.5-20 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE
