Xerox 4050 Operator's Manual
Also see for 4050: Message guideForms creation guideCode ListMessage guideQuick reference card
                                                                                                                                                                        | |
Contents
| 
PRINT JOB MAINTENANCEUsing the FEED commandThe choice of feeder trays for each job can be established eitheras part of the job setup or by you, the operator. When you areusing the FEED command to select feeder trays, keep thefollowing points in mind:• The MAIN cluster is predefined as tray 1, the AUX cluster astray 2, and the AUTO cluster as all the trays physically presentin the printer. However, all of these clusters may have beenredefined at installation. You can also override thesedefinitions with the CLUSTER (CLU) and CLP commands.• The FEED 1 and FEED MAIN commands will not have thesame result, even if the main cluster consists of only tray 1.• Remember to enter the FEED MAIN command after a changeof shift or after the printer is serviced. A previous operatoror a service representative may have instructed the LPS touse a specific tray or cluster to override all the trayspecifications within the jobs you start. The FEED MAINcommand returns control to the printer.Use the following FEED command to select a tray, cluster name,or cluster mode (MAIN, AUX, and AUTO):FEED [MAIN|AUX|AUTO|tray-number|cluster-name](no parameters)If the printer is in FEED MAIN or FEED AUX mode, thecommand with no parameters toggles to the other of thesetwo modes. If the printer is not in one of these two modes,the command has no effect.MAINFeeds from the MAIN cluster and gives the printer control ofpaper sources to ensure that all sheets from a designatedstock name are fed from the assigned cluster.AUXFeeds from the AUX cluster and overrides the feed sourcespecified in the job.AUTOFeeds from the AUTO cluster.tray-numberFeeds from a specified feed tray until you enter another FEEDcommand. This command overrides the feed sourcespecified in the job.cluster-nameFeeds from a specified feed tray until you enter another FEEDcommand. This command overrides the feed sourcespecified in the job.5-16 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE |
Related manuals for Xerox 4050
manualsdatabase
Your AI-powered manual search engine