Product Recycling and DisposalXerox 6204 Wide Format Solution 15Before Using the Machine1Product Recycling and DisposalIf you are managine the disposal of your Xerox product, please note that the productcontains lead, mercury, and other materials whose disposal may be regulate due toenvironmental considerations in certain countries or states. The presence of lead andmercury is fully consistent with global regulations applicable at the time that theproduct was placed on the market.A full declaration of the conformity, defining the relevant directives and referencedstandards, can be obtained from your Authorized Local Dealer.WEEE Directive 2002/96/ECApplication of this symbol on your equipment is confirmation that you must dispose ofthis equipment in compliance with agreed national procedures.In accordance with European legislation, end of life electrical and electronicequipment subjec to disposal must be managed with agreed procedures.Prior to disposal, please contact your local dealer or Xerox Representative for end oflife take back information.Power ConnectionTwo power specifications are listed below. The specifications that apply to yourmachine depend on your machine configuration and the requirements in your country.Connect the power plug only to a properly rated and grounded power outlet to avoidthe chance of electric shocks. If in doubt, contact your Xerox Sustomer SupportCenter.1. Rated voltage 120 VRated frequency 50/60 Hz2. Rated voltage 220-240 VRated frequency 50/60 HzEnsure that the plug connection is free of dust. In a damp environment, acontaminated connector can cause connection problems over time.Do not attempt to rework, pull, bend, chafe, or damage the power cord in any way. Donot place heavy objects on the cord because that can also damage the cord.Stop operation immediately if your machine produces smoke, excessive heat, unusualnoises or smells, or if water, coffee, or other liquids are spilled on the machine.Immediately turn off the machine off and unplug it. Then contact your Xerox CustomerSupport Center.Environment and TemperatureThe machine is designed to operate normally within the following recommended limits:Temperature range: 50 - 90 degrees Fahrenheit (10 - 32 degrees Celsius)Humidity range: 15 - 85% (no condensation)At 47.5% humidity, the temperature should be 90 degrees F or below; andat 85% humidity, the temperature should be 82 degrees F or below.Note • Sudden temperature fluctuations can affect copy quality. Heating a cold room too quicklycan cause condensation inside the machine, which can interfere with image transfer.
