Phaser® 8400 Color PrinterCopyright © 2003 Xerox Corporation. All Rights Reserved.4-36Moving and Repacking the PrinterThis topic includes:■ "Precautions for Moving the Printer" on page 4-36■ "Moving the Printer Within the Office" on page 4-37■ "Preparing the Printer for Shipment" on page 4-39For safety information, go to Reference/Troubleshooting/User Safety on the UserDocumentation CD-ROM.Precautions for Moving the PrinterCautionAlways wait 30 minutes after shutting down the printer before moving it or preparing itfor shipment. This allows time for the ink in the printer to solidify.WarningFollow these guidelines to avoid injuring yourself or damaging the printer:■ Always allow the printer to cool before it is moved to avoid ink spills which can damagethe printer.■ Use the Fast Shutdown mode at the front panel (Shut Down for Moving Printer) forbest results.■ Always turn off the printer using the power switch, located under the interface cover onthe right side of the printer, and unplug all cables and cords. Never turn off the printer bypulling the power cord or using a power-strip with an on/off switch.■ Never move the printer if you receive a Power Down Error-Head not Parked messageat the printer’s front panel. This message means the printer is not ready to be moved. If theprinthead is not locked, the printer can be damaged during shipment.■ Always look at the green flag in the exit tray to ensure that it is in the raised position.When the green flag is raised the printhead is locked.■ Always use two people to lift the printer.■ Always move the printer separately from the 525-Sheet Feeder.■ Failure to repackage the printer properly for shipment can result in damage to the printernot covered by the Xerox warranty, service agreement, or Total Satisfaction Guarantee.NoteThe Total Satisfaction Guarantee is available in the United States and Canada.Coverage may vary outside these areas, please contact your local representative fordetails. (Free Color Printer customers are not eligible for this coverage.)
