Installation Planning Guide 8-18. InstallationThis chapter describes the activities performed by you and Xeroxpersonnel during the installation of the Xerox DocuPrint 100/115/135/155/180 EPS hardware and software components. Beforeinstallation can begin, you must complete the tasks described inthe “Preparing for installation” chapter of this guide.Installation processXerox personnel are responsible for the physical installation ofthe printing system hardware components and the software.NOTE: For customers outside the United States, contact yourlocal Xerox operating company for your specific installationprocess.The installation process can take one or several days tocomplete. Equipment, software kits, and documentation kits mayarrive in one day, or over the course of several days. When all ofthe necessary items are in place, Xerox personnel will completethe installation of the printer components.In the United States, the steps in the installation process typicallyoccur in the following order:1. Xerox personnel install all printer hardware and connects thecontroller to your site’s network through the Ethernetconnector you supply. This process takes approximately fourhours if all the necessary network and electrical connectorsare in place.2. Xerox personnel load software on the controller(approximately 1.5 hours).3. Xerox personnel download Xerox client software, ifapplicable, on one client workstation to validate theinstallation (15 minutes). Software is downloaded on anotherclient workstation as part of training conducted by yoursystems analyst. All other client software installations areyour responsibility.
