SuppliesInstallation Planning Guide A-3• Transparencies: Must be the type designed for high-speedprinters and must meet the specifications described in thesection above. Loading instructions are printed on all papertrays.Load transparencies with the opaque strip to the right. Allprinted transparencies are delivered to the sample tray.As long as they meet your printer’s paper specifications, youcan also use:• Tinted paper: Available in a variety of colors, it has manyuses, including calling attention to certain printed material,separating special sections, or dividing chapters of a report.• Preprinted paper: May be letterhead, forms, or logos.• Predrilled paper: Has a varying number of holes for use inbinders or binder rings. Before loading predrilled paper, fan itto remove loose plugs that could cause paper jams. Loadpredrilled paper in the printer with holes to the right.• Perforated paper• Pre-cut or full tabs• Carbonless paperNOTE: The printer can print on precollated or ordered stocks,including ordered tabs. However, jam recovery is not supportedwith these stocks.Paper sizing and print speedThe printer paper trays have edge guide sensors that detectpaper length and width. The system selects correct paper traysfor the print job based on the paper size specified in the job, asfollows:• If an exact match is found, the print job continues.• If an exact match is not found, the programmer can specify inthe job for the printer to either:– Stop printing the job and print an error sheet– Print the data on an oversized sheet.If you encounter any problems related to paper sizing, contactyour lead operator, systems specialist, or service representative.
