Basic RegulationsXerox® Phaser® 3020 PrinterUser Guide130Basic RegulationsXerox has tested this device to electromagnetic emission and immunity standards. These standards aredesigned to mitigate interference caused or received by this device in a typical office environment.United States (FCC Regulations)This device has been tested and found to comply with the limits for a Class A digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a commercial environment. This device generates, uses, and can radiate radio frequencyenergy. If it is not installed and used in accordance with these instructions, it may cause harmfulinterference to radio communications. Operation of this device in a residential area is likely to causeharmful interference in which case the user will be required to correct the interference at his/her ownexpense.If this device does cause harmful interference to radio or television reception, which can be determinedby turning the device off and on, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiver.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/television technician for help.Changes or modifications to this equipment not approved by Xerox can void the authority of the userto operate this equipment.Note: To ensure compliance with Part 15 of the FCC rules, use shielded interface cables.CanadaThis Class A digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.European UnionCAUTION: This is a Class A product. In a domestic environment, this product can causeradio interference in which case the user could be required to take adequate measures.The CE mark applied to this device symbolizes Xerox’s declaration of conformity with thefollowing applicable Directives of the European Union as of the dates indicated:• December 12, 2006: Low Voltage Directive 2006/95/EC• December 15, 2004: Electromagnetic Compatibility Directive 2004/108/EC• March 9, 1999: Radio & Telecommunications Terminal Equipment Directive 1999/5/EC