IPv6Phaser® 4510 Laser Printer2-14IPv6This section includes:■ Enabling IPv6 on page 2-14■ Setting the Interface ID on page 2-15■ Automatic Address Assignment on page 2-16■ DHCPv6 on page 2-17■ Manual Address Assignment on page 2-18■ Address Precedence on page 2-19Enabling IPv6IPv6 can be enabled or disabled independently of IPv4.Note: If you disable both IPv4 and IPv6, you will lose your connection to the printer. Forinformation on restoring the default TCP/IP settings, see Resetting the TCP/IP Configurationon page 2-15.To enable/disable IPv6, use one of the following options:■ The printer’s control panel■ CentreWare ISUsing the Control PanelTo enable/disable IPv6 on the control panel:1. Select Printer Setup, and then press the OK button.2. Select Connection Setup, and then press the OK button.3. Select Network Setup, and then press the OK button.4. Select TCP/IPv6 Setup, and then press the OK button.5. Select IPv6, and then press the OK button to switch between On and Off.Using CentreWare ISTo enable/disable IPv6 using CentreWare IS:1. Launch your web browser.2. Enter your printer’s IP address in the browser’s Address field.3. Click Properties.4. Select the Protocols folder on the left navigation panel, and then click TCP/IP.5. Click the TCP/IP (v6) button.6. Select the TCP/IP v6 Enabled check box to enable TCP/IP v6.7. Click the Save Changes button at the bottom of the page.
