IPv6Phaser® 4510 Laser Printer2-16Automatic Address AssignmentAddresses are assigned automatically when a router is found that offers one or more prefixes.Automatically assigned addresses are routeable. Each router-supplied prefix is combined withthe Interface ID to create an address. The use of router-supplied prefixes is enabled by default.To enable/disable automatic address assignment, use one of the following options:■ The printer’s control panel■ CentreWare ISEnabling/Disabling Automatic Address Assignment with the Control PanelTo set the Interface ID on the control panel:1. Select Printer Setup, and then press the OK button.2. Select Connection Setup, and then press the OK button.3. Select Network Setup, and then press the OK button.4. Select TCP/IPv6 Setup, and then press the OK button.5. Select Auto Assign, and then press the OK button to turn Auto Assign On or Off.Enabling/Disabling Automatic Address Assignment with CentreWare ISTo set the Interface ID with CentreWare IS:1. Launch your web browser.2. Enter your printer’s IP address in the browser’s Address field.3. Click Properties.4. Select the Protocols folder on the left navigation panel, and then click TCP/IP.5. Click the TCP/IP (v6) button.6. Select/deselect Use router supplied prefixes.7. Click the Save Changes button at the bottom of the page.
