Phaser® 5500 Laser PrinterCopyright © 2004 Xerox Corporation. All Rights Reserved.3-24Windows 98 and Windows MeThis topic includes:■ "Preliminary Steps" on page 3-24■ "Quick CD-ROM Install Steps" on page 3-25■ "Other Methods of Installation" on page 3-25■ "Windows 98 and Windows Me Troubleshooting" on page 3-27■ "infoSMART Knowledge Base Documents (English only)" on page 3-28Preliminary Steps1. Verify that the printer is plugged in, turned On, and connected to an active network.2. Verify that the printer is receiving network information by monitoring the LEDs on theback of the device or on the CentreDirect External Print Server. When the printer isconnected to a functioning network and receiving traffic, its link LED is green, and itsamber traffic LED is flashing rapidly.3. Print a “Configuration Page” and verify that the desired protocol is enabled, then followone of these options:■ Proceed to Step 4 if you do not have a TCP/IP address configured for your printer.■ Proceed to Step 5 if you do have a TCP/IP address configured for your printer.4. Do one of the following if you do not have a TCP/IP address configured for yourcomputer:■ Contact your system administrator to ensure that configuration is made according toyour company guidelines.■ Configure your PC with a unique address such as 192.1.1.1.5. If you have a TCP/IP address, then follow these steps to verify the IP address for your PC:a. Click Start, then click Run.b. Enter winipcfg in the Open field. (If the file is not found, TCP/IP may not beinstalled.)c. Click OK.d. Select your network adapter from the list. The IP address is listed in the IP Addressfield.NoteFor more information about installing and configuring TCP/IP in Windowsenvironments, go to your Microsoft Windows documentation.6. Proceed to “Quick CD-ROM Install Steps” or “Other Methods of Installation” for theinstallation method desired.
