MacintoshPhaser® 5500 Laser Printer3-336. Select the appropriate PPD from the list in the Printer Model drop-down list. If yourprinter PPD is not listed, install it from the Printer Installer and Utilities CD-ROM.7. Click Add to complete the configuration.For more information, go to the table of infoSMART Knowledge Base documents at the end ofthis section.Creating a Rendezvous Printer with Mac OS X, Version 10.2 and Higher1. Open the Print Center utility. In Mac OS X, version 10.3 or higher, the utility is calledPrinter Setup. The utility is located in Utilities in the Applications directory.2. Click Add.A list appears displaying name of your printer, followed by a series of numbers. Forexample, Your Printer’s Name xx:xx:xx. Each numbered segment represents the lastsection of your printer’s hardware address. Your PPD is automatically selected.3. Click Add to complete the installation.Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Version10.1 and Higher)The following procedure eliminates cabling, communication, and connection problems. Onceyou complete these steps, print a test page from your software application. If the job prints, nofurther system troubleshooting is necessary. If there are print quality problems, go toReference/Troubleshooting on the User Documentation CD-ROM.Macintosh Troubleshooting Step-By-StepMac OS 9.xPerform these steps only for Mac OS 9:1. Open the Chooser, then click the LaserWriter driver.2. Do one of the following:■ If the printer’s name appears, your device is communicating through the network. Youdo not need to perform any additional steps.■ If the printer’s name does not appear, proceed to Step 3.3. Verify that the printer is plugged in, turned On, and connected to an active network.4. Verify the cable connection from the network to the printer.5. Follow these steps:a. From the printer’s front panel, verify that EtherTalk is enabled. If it is not, enable it inthe front panel, then reset the printer.b. Print the “Configuration Page” and verify that EtherTalk is enabled.c. From the “Configuration Page”, verify the Zone. If you have multiple zones on yournetwork, verify that your printer appears in the desired zone.
