Phaser 6121MFP Service Manual A-15ReferenceFirmware UpdateNoteThe Phaser 6121MFP print driver must be installed on the PC that is used forthe firmware upgrade. Use the SW & Documentation CDROM (Disk1) to installthe scanner driver in your PC. (The scan driver needs to be installed by thePlug and Play New Hardware Found wizard - the CDROM only copies the filesto the printer.)1. Download the applicable files from the Xerox support web site.2. Connect a USB cable between the PC and the printer.3. Launch the firmware update tool (UpdateFW.exe).4. In the update tool, select the upgrade AmberAIO4IN1_XC_VNNNF00.bin file,and then press Update.5. Examine the printer control panel and wait for the firmware update process tocomplete. When complete, the control panel displays:Firmware UpdateFirmware Update OKMachine Power Off/On6. In the update tool, select the AmberAIO4IN1_XC_VNNNDEMOPAGE.bin file,and press Update. Examine the printer control panel and wait for the firmwareupdate process to complete. When complete, the control panel displays:Firmware UpdateFirmware Update OKMachine Power Off/On7. Press the following keys in this order:OK -> Stop/Reset > 0 > 0 > Stop/Reset > 0 > 1The control panel displays the following:Service ModeService’s ChoiceAdjustmentCounter8. Press the Down key to navigate to Clear Data, and then press OK.9. Select SRAM Clear, and then press OK.10. Select Yes, and then press OK.The control panel displays Accepted SRAM Clear and then returns to themenu.11. Turn the printer off, and then back on.NoteWhen the printer reboots, it prompts you for initial setup configuration.
