Xerox WorkCentre 7232/7242 System Administration Guide 20718 AppendixConfiguring Network Authentication (by a remote Accountingserver)Network authentication uses the user information managed on a remote Accountingserver to manage authentication (access) to available machine services.Enable Network AuthenticationTo enable Network Authentication for use with this Device, at your networkedworkstation, perform the following steps:1. Open your Web browser and enter the TCP/IP address of the machine in theAddress or Location field. Press Enter.2. Click the Properties tab.3. Select the Security folder, then the Authentication Configuration hot link.4. Select Login to Remote Accounts from the Login Type drop-down list, thenNetwork Accounting from the Accounting Mode drop-down list.5. Place a checkmark in the Enable box for each service that you wish to restrictaccess to. For explanations of each service, click the Help button.6. Do not place a checkmark in the Non-account Print box if you wish to enablepeople without accounts to continue to print.7. From the Verify User Details drop-down menu, select either Yes or No (keeplogon records). The Yes selection will verify user information. When No (keeplogon records) is selected, User ID and Account ID must be entered at the Device,but user information will not be checked. A logon record will be kept by theDevice, however.8. If a Guest User box is available and configurable, consider whether it is advisablein your network environment to allow simple password, guest access to thisrestricted service device. The default setting is Off.9. If you wish to allow guest access, enter your guest password twice in the boxesprovided.10. Click Apply and enter the Administrator User name and password whenprompted.11. Click the Reboot Machine button, then OK, when prompted.12. Refresh your web browser, then click on the User Details Setup link to set theStore User Details setting. Note that you can set either NVM or hard disk as the
