6 UNIX TCP/IP78 Xerox WorkCentre 7232/7242 System Administration GuideNOTE: If you do not wish to use the IP filter feature, select [Disabled].NOTE: If you enable IP Filtering at the machine user interface without first configuringit through Internet Services, then you will not be able to access the machine’s InternetServices web page or print to the machine.17. When you have finished establishing TCP/IP, select [Close] on the [ProtocolSettings] screen.When [IPv6 Mode] or [Dual Stack] is selected8. Set [IPv6 Address Manual Configuration].NOTE: Select [Enabled] when the machine is connected to a network on which IPv6stateless address autoconfiguration is disabled, or when you want to set a static IPv6address.If you selected [Enabled] in step 8, proceed to step 9. Otherwise, proceed to step 15.9. Select [IPv6 – Manual IP Address Setup], and then [Change Settings].10. Use the keypad on the screen to enter the IP Address for the machine in theformat “xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx”. Select [Save].11. Select [Manually Configured IPv6 Prefix], and then [Change Settings].12. Set the IP address prefix, and then select [Save].13. Select [IPv6 – Manual Gateway Setup], and then [Change Settings].14. Using the same method as in step 10, set the gateway address.15. To enable IPv6 – IP Filtering, use CentreWare Internet Services to register the IPaddresses that will not be allowed to access the machine.NOTE: If you do not wish to use the IP filter feature, select [Disabled].NOTE: If you enable IP Filtering at the machine user interface without first configuringit through Internet Services, then you will not be able to access the machine’s InternetServices web page or print to the machine.16. When you have finished establishing TCP/IP, select [Close] on the [ProtocolSettings] screen.Workstation SetupThis section explains how to set up Solaris, SunOS, and HP-UX workstations. Refer tothe relevant instructions below.Solaris – page 80SunOS – page 81HP-UX – page 82
