13 Scanning Services138 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide5. Select a method for establishing an IP Address from [DHCP], [BOOTP], [RARP],[DHCP/Autonet], or [Manual], and then select [Save].NOTE: Use the DHCP server together with the Windows Internet Name Server(WINS) server.If you selected [Manual] in step 5, then complete steps 6 to 11 to enter the [ProtocolSetting]. Otherwise, complete step14.6. Select [TCP/IP - IP Address], then [Change Settings].7. Use the keypad on the screen to enter the IP Address for the machine in theformat “xxx.xxx.xxx.xxx”. Enter relevant values 0 to 255 into the highlighted fieldand select [Next]. The next 3 digits are highlighted. When you have finishedentering all values, select [Save].8. Select [TCP/IP -Subnet Mask], then [Change Settings].9. Using the same method as in step 7, enter the Subnet Mask.10. Select [TCP/IP -Gateway Address], then [Change Settings].11. Using the same method as in step 7, enter the Subnet Mask.NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.12. Select [TCP/IP - IP Filter], then [Change Settings].13. Select [On] to filter access to the machine.NOTE: If you do not wish to use the IP filter feature, select [Off].NOTE: Use CentreWare Internet Services to register the IP addresses which are notallowed to access the machine. Refer to the CentreWare Internet Services chapter ofthe User Guide.14. When you have finished establishing TCP/IP, select [Close] from the [ProtocolSettings] screen.Workstation SetupYou need the folder to store scanned data. Create a folder on your computer, and thenenable sharing for the folder.NOTE: When you use UNC format for SMB, only local access is allowed.
