3 Electrical InstallationYASKAWA ELECTRIC TOEP C710616 21C YASKAWA AC Drive - A1000 Quick Start Guide 51Electrical Installation3Table 16 Parameter H3-09 Details◆ Connect to a PCThis drive is equipped with a USB port (type-B).The drive can connect to the USB port of a PC using a USB 2.0, AB type cable (sold separately). DriveWizard Plus canthen be used to monitor drive performance and manage parameter settings. Contact Yaskawa for more information onDriveWizard Plus.Figure 46Figure 46 Connecting to a PC (USB)◆ Wiring ChecklistNo. Parameter Name Description SettingRange DefaultSettingH3-09 Terminal A2 signal level selectionSelects the signal level for terminal A2.0: 0 to 10 Vdc1: -10 to 10 Vdc2: 4 to 20 mA3: 0 to 20 mA0 to 3 2No. Item PageDrive, peripherals, option cards1 Check drive model number to ensure receipt of correct model. 172 Make sure you have the correct braking resistors, DC reactors, noise filters, and other peripheral devices. –3 Check the option card model number. –Installation area and physical setup4 Ensure that the area surrounding the drive complies with specifications. 19Power supply voltage, output voltage5 The voltage from the power supply should be within the input voltage specification range of the drive. 756 The voltage rating for the motor should match the drive output specifications. 171727 Verify that the drive is properly sized to run the motor. 17172Main circuit wiring8 Confirm proper branch circuit protection as specified by national and local codes. 269 Properly wire the power supply to drive terminals R/L1, S/L2, and T/L3. 2810Properly wire the drive and motor together.The motor lines and drive output terminals R/T1, V/T2, and W/T3 should match in order to produce thedesired phase order. If the phase order is incorrect, the drive will rotate in the opposite direction.4111 Use 600 Vac vinyl-sheathed wire for the power supply and motor lines. 35PC(Type-B) (Type-A)USB Cable(Type-AB)YEC_common