2.4.3 Mounting periphery moduleYou have the possibility to extend the periphery area of the CPU by plugging up to 8periphery modules. For this the periphery modules are plugged at the right side of theCPU. The mountings happens with the following proceeding:1. Remove the bus cover with a screwdriver on the right side of the CPU.2. Each periphery module has a locking lever on its upper and lower side. Pull theselevers outwards as shown in the figure, until these engage audible.CAUTION!It is not allowed to mount the module sideways on the mounting rail,as otherwise the module may be damaged.3. To mount plug the periphery module from the top onto the mounting rail and turn theperiphery module downward until it rests on the mounting rail.4. Attach the periphery module to the CPU by sliding the periphery module on themounting rail to the left until the interface connector slightly locks into the CPU.5. To fix the periphery module at the mounting rail, move the locking levers back to theinitial position.6. Proceed in this way with additional periphery modules.ProceedingVIPA System MICROBasics and mountingMounting > Mounting periphery moduleHB400 | CPU | M13-CCF0000 | en | 18-5018
