4 Deployment CPU M13-CCF00004.1 AssemblyInformation about assembly and cablingÄ Chap. 2 ‘Basics andmounting’ page 11.4.2 Start-up behaviorn The CPU checks whether a project AUTOLOAD.WLD exists on the memory card. Ifso, an overall reset is executed and the project is automatically loaded from thememory card.n The CPU checks whether a command file with the name VIPA_CMD.MMC exists onthe memory card. If so the command file is loaded from the memory card and thecommands are executed.n After PowerON and CPU STOP the CPU checks if there is a *.pkb file (firmware file)on the memory card. If so, this is shown by the status bar of the CPU and the firm-ware may be installed by an update request.Ä Chap. 4.13 ‘Firmware update’page 96n The CPU checks if a previously activated VSC is inserted. If not, this is shown by thestatus bar of the CPU and a diagnostics entry is released. The CPU switches toSTOP after 72 hours. With a just installed VSC activated functionalities remain acti-vated.Ä Chap. 4.19 ‘Diagnostic entries’ page 105After this the CPU switches to the operating mode, which is set on the operating modeswitch.In the delivery state the CPU is overall reset. After a STOP®RUN transition the CPUswitches to RUN without program.Turn on power supplyDelivery stateVIPA System MICRO Deployment CPU M13-CCF0000Start-up behaviorHB400 | CPU | M13-CCF0000 | en | 18-50 65
