InstallationThis chapter describes the installation procedure for integrating the FT-2980R into atypical amateur radio station. It is presumed that you possess technical knowledge andconceptual understanding consistent with your status as a licensed radio amateur. Pleasetake some extra time to make certain that the important safety and technical requirementsdetailed in this chapter are followed closely.Preliminary InspectionInspect the transceiver visually immediately upon opening the packing carton. Confirmthat all controls and switches work freely, and inspect the cabinet for any damage. Gentlyshake the transceiver to verify that no internal components have been shaken loose dueto rough handling during shipping.If any evidence of damage is discovered, document it thoroughly and contact the shippingcompany (or your local dealer, if the unit was purchased over-the-counter) so as to getinstructions regarding the prompt resolution of the damage situation. Be certain to savethe shipping carton, especially if there are any punctures or other evidence of damageincurred during shipping; if it is necessary to return the unit for service or replacement, usethe original packing materials but put the entire package inside another packing carton, soas to preserve the evidence of shipping damage for insurance purposes.Installation TipsTo ensure long life of the components, be certain to provide adequate ventilation aroundthe cabinet of the FT-2980R.Do not install the transceiver on top of another heat-generating device (such as a powersupply or amplifier), and do not place equipment, books, or papers on top of the FT-2980R. Avoid heating vents and window locations that could expose the transceiver toexcessive direct sunlight, especially in hot climates. The FT-2980R should not be used inan environment where the ambient temperature exceeds +140 °F (+60 °C).9FT-2980R Operating Manual