Yaesu FT-70DR Advance Manual

Also see for FT-70DE: Operating manual Operating manual Operating manual Manual Instruction manual

Yaesu FT-70DR Advance Manual Manual pdf 24 page image

24FT-70DR/DE Advance ManualReset AllUse this procedure to restore all settings to their original factory defaults. All Memorieswill be cleared by this procedure.CAUTION!Resetting will clear all memories and all settings to the factory default. Be sure to make a note of theMemory Channel and Set Mode settings, etc. before resetting.1. Turn the transceiver OFF.2. Press and hold the [MODE] key, [HM/RV] key andthe [AMS] key simultaneously, while turning thetransceiver ON.The beep sounds and the confirmation screen isdisplayed.3. Press the [F] key to sound beep and reset all fac-tory defaults.• After resetting all defaults, the call sign inputmessage appears on the LCD. Set the call sign.(See the operating manual)To cancel the resetting, press any key except the [F] key.Set Mode ResetThe Set mode only reset will restore all the Set Mode Items to the default settings. Theuser memory channels will not be reset.CAUTION!Resetting will clear all Set Mode MENU items to the factory default. Be sure to make a note of anyuser customized Set Mode settings, etc. before resetting.1. Turn the transceiver OFF.2. Press and hold the [MODE] key and the [V/M]key and turn the transceiver ON simultaneously.The beep sounds and the confirmation screenis displayed.3. Press the [F] key to sound a beep and resetthe Set Mode settings.To cancel the resetting, press any key except the[F] key.The Set Mode Reset may not reset the following Set Mode items.To restore all of the following Set Mode items to default, perform All Reset:1 ANT.ATT 8 BELL 9 BNK.NAM 11 CLK.SFT 13 DCS.INV19 DT SET 33 MEM.NAM 35 NM/FRQ 36 OPN.MSG 37 PAG.ABK38 PAG.CDR 39 PAG.CDT 41 PSWDWT 44 RF SQL 46 RPT.FRQ47 RX MOD 49 SCM.WTH 50 SCV.WTH 54 SQL.EXP 61 W/N.DEV62 MYCALL