52 FT-7800R OPERATING MANUALCW Identifier SetupThe ARTS feature includes a CW identifier, as discussed previously. Every ten minutesduring ARTS operation, the radio can be instructed to send “DE (your callsign) K” if thisfeature is enabled. The callsign field may contain up to 6 characters.Here’s how to program the CW Identifier:1. Press and hold in the [BAND(SET)] key for 1/2 second to enter the Set mode.2. Rotate the DIAL knob to select Menu #8 (CW WRT).3. Press the [BAND(SET)] key momentarily.4. Press the [BAND(SET)] key momentarily again to en-able entry of your callsign.5. Rotate the DIAL knob one click clockwise to begin en-try of the letters and numbers in your callsign.6. Press the [BAND(SET)] key momentarily to set the firstletter or number in your callsign.7. When the correct character has been selected, press the[BAND(SET)] key momentarily to move on to the nextcharacter.8. Repeat steps 6 and 7 as many times as necessary to com-plete your callsign.9. Press the [SCAN(SEL)] key to delete all data after thecursor that may have been previously stored (errone-ously).10. When you have entered your entire callsign, press and hold in the [BAND(SET)] keyfor 1/2 second to confirm the callsign, then press and hold in the [BAND(SET)] key for1/2 second to exit to normal operation.11. Press and hold in the [BAND(SET)] key for 1/2 secondto enter the Set mode again, then rotate the DIAL knobto select Menu #7 (CWID).12. Press the [BAND(SET)] key momentarily, then rotatethe DIAL knob to select “TX ON” (to enable the CWidentifier).13. Press the [BAND(SET)] key momentarily to save the new setting, then press and hold inthe [BAND(SET)] key for 1/2 second to exit to normal operation.ARTS ™: AUTO R ANGE T RANSPONDER S YSTEM