Yaesu FT3Dr Instruction Manual

Also see for FT3DE: Operating manual Manual Instruction manual Instruction manual Operating manual

Contents

56ITEM: ON: ITEM BEACON information (BEACON displayed as [I] or [i] on LIST)is output with WAPOINT data.OFF: ITEM BEACON information is not output when set to OFF.TipIf you are to connect the transceiver with a PC using CT-169, the following settings must be appliedon the PC.DATA SPEED: 9600bps (the SPEED setting of this transceiver and a PC must correspond).DATA LENGTH: 8bitParity Bit: NoneStop Bit: 1bity 18 DIGI PATHSetting the digipeater route.Setting item: P1 OFFP2: WIDE1-1 (fixed value)P3: WIDE1-1, WIDE2-1 (fixed value)P4 to P7: Up to 2 addresses can be entered arbitrarily.P8: Up to 8 addresses can be entered arbitrarily.Default: P3: FWIDE1-1 AWIDE2-1 (fixed value)Explanation:A station that relays packets, such as beacons, is called a digipeater.Select a CALLSIGN or ALIAS of the digipeater you would like to use.In this transceiver, [WIDE1-1] (setting for 1 relay station) and [WIDE1-1/WIDE2-1] (settingfor 2 relay stations) is the default.In [WIDE1-1, WIDE2-1], a transmission is relayed to the first digipeater station specifiedas WIDE1-1, then to the second digipeater station specified as WIDE2-1.In the USA, digipeater stations used by APRS are customarily operated using *New-Paradigm.The initial values set to this transceiver are premised for digipeater stations operating withNew- Paradigm, because most digipeater stations support this method.In order to use other relay methods, select one of P4 to P8 and enter the CALLSIGN orALIAS.* For information on the New-Paradigm method, refer to the following website for details.http://aprs.org/fix14439.html