FTA-310 OperATing MAnuAl42vor navIgatIonSplit OperationThe split operation feature allows you to transmit a callto a Flight Service Station using the COM band frequen-cies, while receiving a VOR station (in the NAV band).VOR stations equipped with this capability typically areshown, on navigation charts, with the voice calling fre-quency in parenthesis above the navigation frequency.Programming a Transmit Frequency Press downward on the VOLUME knob, repeatedlyif necessary, to select the VFO mode. Set a NAV band (108.000 - 117.975 MHz) frequen-cy using the DIAL selector knob or keypad. Press the [F] key momentarily, then press the [MW(SPL-W)] key. The “ ” icon will blink, and thetransmit frequency will appear on the display. Now set your radio’s transmit frequency, where theFlight Service Station will be listening for calls, us-ing the DIAL selector knob or keypad. Press and hold in the [MW (SPL-W)] key for 2 sec-onds to save the transmit frequency and return to theNAV band frequency.Note: You have now stored the separate transmit fre-quency, but you have not yet activated the split-frequen-cy function; go on to the next section.Operating in the Split Mode It is assumed that you have already set the desiredVOR station’s frequencies (in the NAV band) perthe above instructions. Press the [F] key momentari-ly, then press the [7 (SPL)]key to turn on the “Split”function. The “ ” iconwill appear on the display. Press and hold in the PTT switch to transmit on thesplit transmit frequency. Release the PTT switch to return to the receivemode. To disable the “Split” function, press [F] [7 (SPL)] again.Note: A split frequency can be programmed into eachmemory channel independently. Set a transmit frequen-cy before programming the memory channel, if desired.The split function on/off setting can also be programmedinto a memory channel.