64ScanningSearching for signalsMemory scanFrequencies registered to the memory channels can be scanned in the memory channelnumber order.1 Switch to memory mode.2 Press and hold [UP] or [DWN] on the microphone forover one second.Pressing [UP] scans the memory channels in anupward direction.Pressing [DWN] scans the memory channels in adownward direction.During scanning, the decimal point of the frequencydisplay blinks.Once the transceiver receives a signal, thetransceiver continuously receives it until the signaldisappears, and restarts scanning 2 seconds afterthe signal disappears.Tips • The scanning direction (UP/DOWN) can be set from [5SCAN] → [2 SCAN DIRECTION] in the Setup menu.(This direction setting is also applied to scanningperformed using one of the [P1] to [P4] keys on themicrophone. The [SCAN] function can be assignedto the key in advance using [8 CONFIG] → [10 MICPROGRAM KEY] in Setup menu).• The scanning direction can be changed by pressingand holding [UP] or [DWN] for over one second on themicrophone or rotating the DIAL during scanning.• The receiver operation after scanning stops can be setfrom [5 SCAN] → [2 SCAN RESUME] in the Setupmenu (refer to the previous page).• Press , and then rotate the DIAL to adjust thesquelch level, even during scanning.● Canceling scanningTo cancel scanning, press [PTT] on the microphone (this does not put the transceiverinto transmit mode).
