6C13G11 6-40123456789Disassembling the lower case1. Remove the taper roller bearing outerrace and shim(s).NOTE:Install the claws as shown.2. Remove the drive shaft bearing outerrace, shim(s), and drive shaft sleeve.NOTE:Install the claws as shown.3. Remove the needle bearing.Checking the pinion and forwardgear1. Check the teeth of the pinion, and theteeth and dogs of the forward gear forcracks or wear. Replace if necessary.Checking the bearings1. Check the bearings for pitting or rum-bling. Replace if necessary.Checking the drive shaft1. Check the drive shaft for bends or wear.Replace if necessary.2. Measure the drive shaft runout.Checking the lower case1. Check the skeg and torpedo for cracks ordamage. Replace the lower case if nec-essary.Bearing outer race pullerassembly 1:90890-06523Stopper guide plate 2: 90890-06501Stopper guide stand 3:90890-06538Bearing puller assembly 4:90890-06535Needle bearing attachment 5:90890-06611Driver rod L3 6: 90890-06652Runout limit: 0.5 mm (0.020 in)S66T6380Drive shaft and lower case (FT50, FT60)
